Eight points for attention in the installation and

Eight points to pay attention to in the installation and use of reducer

reducer is a common power transmission company headquartered in Xiamen Da mechanism, which is applied in various mechanical transmission systems. The installation and use of reducer is directly related to the operation effect of reducer, and it should comply with technical specifications and standards. Reasonable installation and use of reducer 1. During the long-term operation of the equipment, pay attention to the following matters

1. When installing the reducer, pay special attention to the alignment of the transmission center axis, and the alignment error cannot exceed the use compensation of the coupling used by the reducer. After the reducer is aligned as required, it can obtain more ideal transmission effect and longer service life

2. When installing the transmission parts on the output shaft of the reducer, attention must be paid to the softness of operation. Rough installation with tools such as hammers is prohibited. It is best to use the assembly fixture and the internal thread of the end shaft for installation, and press the transmission parts into the reducer with the force of bolt screwing, so as to protect the internal parts of the reducer from damage

3. There are many optional types of couplings used in the reducer, but it is best not to use rigid fixed couplings. The installation of such couplings is difficult. Once installed improperly, the load will increase, which is easy to cause damage to the bearing, and even the fracture of the output shaft

4. The fixing of the reducer is very important to ensure stability and firmness. Generally speaking, we should install the reducer on a horizontal foundation or base. At the same time, the oil in the oil drain tank should be drained and the cooling air circulation should be smooth. If the reducer is not fixed well and the foundation is not reliable, it will cause, vibration and other phenomena, and will also cause unnecessary damage to the bearings and gears

5. When necessary, the transmission coupling of the reducer should be equipped with protective devices, such as protrusions on the coupling or the use of gears, sprockets, etc. if the radial load borne by the output shaft is large, the reinforced type should also be selected

6. The installation position of the reducer should ensure the operation of the staff, including the convenient access to the vernier, vent plug, oil drain plug and other positions. After the installation of the reducer, the inspectors should comprehensively check the accuracy of the installation position in order to determine the reliability of each fastener

7. Before the reducer is operated, it is also necessary to prepare for operation, remove the vent plug of the oil pool and replace it with a vent plug, open the oil level plug screw to check the oil line height, add lubricating oil beyond the oil level plug screw until the hole overflows, then screw on the oil level plug and confirm that it is correct, and then start the trial operation

8. The trial run time of the reducer should not be less than two hours. The car is also an essential means of transportation for people. The standard for normal operation is that it operates smoothly, without vibration, noise, leakage and impact. If there is any abnormal situation, FGH systems also provides a shuttle blow molding equipment called Milacron uniloy for commercial production, the common situation should be eliminated in time